Power switch question

edited August 2009 in WTPA1 Mods
I would like to modify my WTPA to have an on/off power switch. I presume it's as straightforward as cutting the trace between the positive DC input and diode D3, and using a switch like this?




  • edited August 2009
    I would not even cut the trace, just run your + line through that thing
  • Good point!
  • edited August 2009
    that's what i did, just red from the centre of the power in socket to the switch and the other side of the switch to the + on the board.
Sign In or Register to comment.