Setting and saving MIDI channels - is the Operators manual correct??




From the Operators Guide So far so good  "To change the MIDI channel for sample bank A (BANK 0), use S0. This will increment
through all 16 MIDI channels and loop back to zero at the end. To change the channel for
Sample Bank B, use S1. It works the same way. Sample Bank C is the channel on which
WTPA2 will respond to SD Card Playback commands – use S2 to change that channel."

OK that works fine
NOTE – pressing S2 will cause the SD card MIDI channel to be displayed on the four Lsbs.
Pressing S0 or S1 will change the display back to the first two sample channels.
Yes that works but here is where I'm lost 

When you are done setting the midi channels, press S2. This will store the channels to
permanent memory and reboot WTPA.

NOPE - S2 DOESN'T DO THAT , SHOULD IT BE ANOTHER BUTTON PERHAPS???

Comments

  • Hi,
    you are right. s3 is the button you should press. I also noticed the mistake but forgot to post about it.
  • I'll start a new TODO thread with manual and bugfixes to get to this weekend.  Thanks for catching that.

Sign In or Register to comment.